Panel molding dates back to the Georgian period of 1700. Georgian architecture is characterized by a sense of proportion and balance. Symmetry and adherence to classical rules were evaluated as normal and desirable. The forms of the panel now used to break large areas, which gives a formal most of the projects. It 'also used as a boundary between colors and textures. Visually enhance any room with decorative panel molding, doors and walls to the ceiling, thisexquisite accents for the average home DIY to install.
As with any project, proper safety equipment be used at any time. This includes wear hearing and eye protection accordingly. If you must use a respirator, dust mask or some other tool or equipment, always choose the right one for the job.
Planning
If at the beginning of a project, it is important to plan the layout. Develop a plan keeps the work flowing smoothly. And 'maybe' smost important step. Although the design of the panel installation requires a good design that shows exactly the space and patterns that do not need to generate detailed plans. To make a pencil sketch on graph paper will. Make sure that the measures are correct. Reference dimensions in the drawing is at the center of the room (or on a ceiling or ceiling dome, medallions, etc..) O on the walls. This is the dominant feature of the design. Although notInterest in the reconstruction of an extravagant baroque ceiling for your home, you can often find some great ideas, studying the pattern of the ceiling, castles and historic buildings. Look around your room and decide if you have full-or split boards, individual size or sizes or large symmetrical plates. Molding of the panel is strictly a decorative element, so there are no rules to follow for the design. This is your opportunity to create a unique and individualDesign.
Order
When you order your panel molding, make sure that the part model with the corners (if you're with the corners), and you have made an adequate allowance for waste. Remember to take into account the report to determine if the waste. I like to use a cut list for all trim work. It allows me to plan all the joints before you begin cutting. I use the same list to schedule my appointment. Normally, the panel due to its low cost launchProfile. Therefore, it is possible to do some work, and then save enough to eliminate as many joints as possible. It may also be adhesive, sealant, etc. needed to complete the installation.
Seed
If you're not going to finish (paint or faux finish) the ceiling and the molding in the same, one can only form part of prefinish and then touch it after installation.
Assemble materials
Set up a work close to work and assemble the tools and materials. Viewthe bar was damaged and to provide them for shipment or at work. Inventory tools and materials to ensure that everything needed is there. If something is missing, stop and do it now rather than wait until you need it, inevitably, in the worst possible time.
Disposal
Transfer the project to cover in full size. Layout of the outline of the shape and the lines of the center so that the layout is installed with visible mold.Remember model ceilings, domes, rosettes, surrounded the center of the frame of reference feature. Reference moldings on the walls that run parallel to the wall (or minimize the effect of the square corrugated walls) are running.
Install
They are necessary because of their low weight, no mechanical fasteners. Use an appropriate size bead of adhesive and temporary fasteners, if necessary until the glue in September
Complete
Cured after the adhesive is to remove thetemporary closures or set below the surface. Caulk the joint between the ceiling and molding. Fill the holes through which fasteners with non-shrink filler, sand, and paint done first.
Voila! Enjoy, enjoy, and in light of all the compliments you receive, if different, that's nice to see your room with the simple addition of panel molding.
Copyright 2006 www.goceilingmedallion.com
0 comments:
Post a Comment